AQP4 Antilichaam / Aquaporine 4

In skeletal muscle, AQP4 (aquaporin 4 also known as mercurial insensitive water channel), localizes to the sarcolemma of fast-twitch muscle fibers. Aquaporins (AQPs) are a large family of integral membrane water transport channel proteins that facilitate the transport of water through the cell membrane. This function is conserved in animals, plants and bacteria. Many isoforms of aquaporin have been identified in mammals, designated AQP0through AQP10. Aquaporins are widely distributed and it is not uncommon for more than one type of AQP to be present in the same cell. Although most aquaporins are only permeable to water, AQP3, AQP7, AQP9 and one of the two AQP10 transcripts are also permeable to urea and glycerol. AQP2 is the only water channel that is activated by vasopressin to enhance water reabsorption in the kidney collecting duct. Aquaporins are involved in renal water absorption, generation of pulmonary secretions, lacrimation and the secretion and reabsorption of cerebrospinal fluid and aqueous humor.

Immunohistochemistry (FFPE) : 1-2 µg/mL

P55087

Human

A human partial recombinant protein (from within amino acids 200-323) was used as the immunogen for the AQP4 antibody.

AQP4/3322

IHC-P

Protein G affinity

Purified

This AQP4 antibody is available for research use only.

Aliquot the AQP4 antibody and store frozen at -20°C or colder. Avoid repeated freeze-thaw cycles.

0.2 mg/mL in 1X PBS with 0.1 mg/mL BSA (US sourced), 0.05% sodium azide

Optimal dilution of the AQP4 antibody should be determined by the researcher.

Cell membrane, cytoplasm

Analysis of HuProt (TM) microarray containing more than 19,000 full-length human proteins using AQP4 antibody (clone AQP4/3322) . These results demonstrate the foremost specificity of the AQP4/3322 mAb. Z- and S- score: The Z-score represents the strength of a signal that an antibody (in combination with a fluorescently-tagged anti-IgG secondary Ab) produces when binding to a particular protein on the HuProt (TM) array. Z-scores are described in units of standard deviations (SD's) above the mean value of all signals generated on that array. If the targets on the HuProt (TM) are arranged in descending order of the Z-score, the S-score is the difference (also in units of SD's) between the Z-scores. The S-score therefore represents the relative target specificity of an Ab to its intended target.